Thread: Drill Motor Inconsistency
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:34
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Drill Motor Inconsistency
Posted by P.J. Baker, Engineer on team #177, Bobcat Robotics, from South Windsor High School and International Fuel Cells.

Posted on 4/15/99 12:24 PM MST


In Reply to: Drill Motor Inconsistency posted by Raul on 4/15/99 10:14 AM MST:



I don't know of an easy SW fix, but make sure that it isn't a problem w/your speed controllers (i.e. test motor speed hooked up directly to a battery). I'm sure that you guys have tried this, but it's the only thing that comes to mind. Good luck. I'm looking forward to visiting Wildstang in the pits next week.

P.J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.