Quote:
Originally Posted by AdamHeard
What is the weight on them?
Also, is it housed in 5 x 3 extrusion similar to the single speed/ super shifter?
|
The extrusion is different, but the same overall width. This gearbox uses smaller screws (#10-32). The extrusion wall thickness is 1/8". The hole pattern is different, and is not meant to match up with the AM Gearbox or Super Shifter. The side plates are 1/4" polycarbonate. It will be light. My guess is that it will be about 1.5 lbs... maybe less.
Due to the speed needed of development combined with the simple design, we did not make a prototype. We went straight to production from CAD. We'll see if this risk turns out well.
Andy