Thread: *unofficial* FIRST IR module driver released
View Single Post
  #1   Spotlight this post!  
Unread 17-12-2007, 11:24
Kevin Sevcik's Avatar
Kevin Sevcik Kevin Sevcik is offline
(Insert witty comment here)
FRC #0057 (The Leopards)
Team Role: Mentor
  
Join Date: Jun 2001
Rookie Year: 1998
Location: Houston, Texas
Posts: 3,721
Kevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond repute
Send a message via AIM to Kevin Sevcik Send a message via Yahoo to Kevin Sevcik
Re: FIRST IR module driver released
Jacob,

I saw in your code that you're restricting the inputs to IOs 1-6 because they have selectable pullup resistors. This isn't necessary. The outputs of the IR board can sink 8.5mA when driven low, which is easily enough to counteract any pullup resistor. Admittedly, this would be a problem if the IR outputs went to High-Z when there wasn't a signal, but i think it's safe to assume that as long as they have power, they're driving the outputs between high and low and thus you don't have to worry about pullups.
__________________
The difficult we do today; the impossible we do tomorrow. Miracles by appointment only.

Lone Star Regional Troubleshooter