Quote:
Originally Posted by RyanN
The back of the board is flat with no components and a few traces. I would put some space between it and a piece of metal. Vivek, have you tried to program it? You need to hold down the tact button before you connect the power to enter programming mode. Continue holding the button down for 2 seconds then release the button while keeping the power on. Then the CMD0 light will come on. Press down a button on the remote control you want to use until the CMD0 light flashes off, then on and turns off again illuminating the next LED (CMD1). Here is the video of ours working. It's really easy setup.
http://youtube.com/watch?v=G9U7flxTDes |
no, I have not tried to program it. Thanks for the information
thanks, vivek