Thread: Drill Motors
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:53
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Drill Motors
Posted by Tim Murray, Student on team #126, Gael Force, from Clinton High School and NYPRO inc..

Posted on 5/5/99 7:36 PM MST


In Reply to: Drill Motors posted by Tom Vanderslice on 5/3/99 8:56 PM MST:



I'm a little familiar with them but i couldn't pull them
apart into a million pieces and put them back together
again like i've seen people do before. i've done a little
work with them but not much. I could and would love to help
you out with them. Just tell me what you need and if I don't
know it, i can consult one of my teachers who knows all about
them.

Tim


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.