Quote:
Originally Posted by Beth Sweet
Ok folks, I have it on very good authority how this game piece is going to be used. Please pay close attention to the directions, otherwise, yours will not work properly:
1: You're going to need 2 blank sheets of white paper and a pencil. A pen will not do.
2: You need to be in a location where you will not be interrupted. You will have very limited time once you start.
3: Sit down at a large table, you will need to spread out
4: Take your game piece sent to you in the mail. Place the piece front side up on the table, and drape the first piece of paper over it like a tablecloth
5: Making sure that the paper stays in place, take your pencil and holding it horizontally, rub it across the paper back and forth from one side of the board to the other until you get a full scale drawing
6: Turn the board piece upside down and do the same with the other piece of paper
7: Now this step is very important. Take your 2 sheets of paper and 2 pieces of tape, and hang the papers on your door or on your cubicle. You now have artwork to remind you of all of the fun you had anticipating the 2008 game.
Enjoy the water game! 
PS. What did you think you were going to get from the non-techy!? |
now this is one of the best posts so far! it focuses on what we have in hand instead of wishing that the board would do fantastic things.
i have already posted 4 clues.
anyone who is serious about solving this puzzle needs to examine the board.
CLUE# 5
the programmers might best like this clue. on the robot controller the digital inputs are the most used connections for feedback devices. we often come close to using all these inputs. so why would first design a board with 4 ouputs?
only a single remote can be detected at any time. thus only a single output line will pulse. this provides 4 pieces of information. it takes only 2 bits to hold 4 different values. the board should have 2 signal lines if the robot controller is to use this IR detector.
therefore, this will not be on the robot. we should try to determine what field-device could be activated by the 100 ms pulse from this board. there must be 4 gates, or 4 containers, or 4 of something.
jerry w