Thread: 1999 Default Program...
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 23:09
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
It is not so bad as all that...
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 6/12/99 7:06 PM MST


In Reply to: Re: 1999 Default Program... posted by Ruby on 6/11/99 2:04 PM MST:



Ruby,

The default program is not all that bad really once you break it down a bit.

There is a bunch of 'house keeping' stuff at the beginning.

There is the main loop where almost all of your customization will go.

In addition to this there are a hand full of subroutines for doing stuff like reading from the switch inputs, outputting to the relays, and commuicating with the Serial Servo Controller (SSC -- it is the chip that creates the signals for the Tekins and the Victors). Most folks don't touch these parts of the code at all. I think we made one or two minor changes for reasons I can't recall right now, but basically, you can ignore this section until you feel up to it.

It is pretty simple once you look at it for a while.

Ask questions on this forum if you get stuck. Many experts are around to help.

Good Luck.

Joe J.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.