|
Re: Probem transfering program from easyC to bot
Make sure you are connected to a port other than Com1 or Com2 as shown in the attachment.
If unknown is shown anywhere, one of the USB ports is not connected to the controller. Coms 1 and 2 are the serial ports and do not connect to the USB connector.
Hope this helps, it was an issue with our controllers.
__________________
Randy Decker
Computer/Networking Technology, PLTW DE/IED,
and Electronic Systems Technician Teacher
Walker Career Center
Indianapolis, IN
www.warrenrobotics.org
2008 Boilermaker Regional J&J Gracious Professionalism Award
2008 Bloomington Vex Champion
2007 St. Louis Regional Champion
|