Thread: Mounting two output sprockets on andyMark :confused:
View Single Post
  #4   Spotlight this post!  
Unread 10-01-2008, 21:16
AndyB's Avatar
AndyB AndyB is offline
Ambitiously Disappointing
AKA: Andy Burchardt
FRC #0171 (Cheese Curd Herd)
Team Role: College Student
  
Join Date: Mar 2005
Rookie Year: 2004
Location: Platteville, WI
Posts: 1,185
AndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond reputeAndyB has a reputation beyond repute
Re: Mounting two output sprockets on andyMark :confused:
There is enough room to fit two 3/4" width sprockets on the output shaft. If you do need a longer shaft, AM does not supply a longer shaft for the toughbox. However, if you purchase the single speed 2" longer shaft and work the short end down from 1/2" to 3/8" with a lathe (its unhardened steel) the shaft is pretty much identical to that supplied with the toughbox... except longer.

Make sure when purchasing a second set of sprockets to buy with a spline... we need to broach ours now.
__________________
Team 171 :: Cheese Curd Herd :: College Mentor, 2008-Present
Team 269 :: CooneyTech Robotics :: Student, 2005-2007