|
Re: Toughbox Assembly
We have had similar problems with the roll pins and large shaft.
We bent two pins trying to get them inserted. We were using an arbor press to insert them. When the pin was flush with the opposite side they would mushroom. We went and inserted spilit roll pins.
The large shaft was .002 too big. We put the shaft in the chuck of our drill press and used emory cloth to get it down so it the bearing would slide on.
__________________
We Build Robots and Careers
World's - #1 seeded in Archimedes, WON Archimedes and made it to Einstein
2016 NC District - Guilford County. #13 seeded, Finalist. Won Quality award.
IN District - Tippecanoe. #4 seeded. Won Innovation in Control award.
IN District - Perry Meridian. #3 seeded. Finalist. Won Excellence in Engineering award.
IN District - State Championship. #1 seeded. Finalist. Won Excellence inn Engineering award.
|