Thread: How did the STAMP training workshop go?
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:11
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
How did the STAMP training workshop go?
Posted by Chris Mikus.

Engineer on team non yet from none yet sponsored by none yet.

Posted on 11/15/99 8:46 AM MST



Did anyone go to any of the training workshops that Parallax presented? How did it go? Did they talk about any specific tricks & tips for a FIRST robot or was the conversation kept to the STAMP in general?

I went to the SMC sponsored pneumatics seminar. They did a fair job at teaching 'basic pneumatics' but I felt that it would of been better if they did a 'show and tell' type presentation focusing on what was given in the kits in the past.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.