|
Re: Cold in a Can
Posted by Lora Knepper.
Student on team #69, HYPER, from Quincy Public Schools and The Gillette Company.
Posted on 12/19/99 7:56 AM MST
In Reply to: Re: Cold in a Can posted by Jerry Eckert on 12/18/99 10:51 PM MST:
We always applied the spray to the external housing of the motor. It works best on the drill motors that heat up quickly (especially if they are your drive train motors!). Hope that helps!
Lora Knepper
driver~team 69 HYPER
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|