[team877]

Hey everyone i have a few questions that i would like to ask.

FIRST of all......i want to make sure that the IR wires should be plugged into the signal pin of the digital input robot controller.
I run easy C and when i run the terminal program on it, it tells me that the robot is sensing the ir sensor but all the inputs are always at one, and then when you press one of the ir buttons it changes the three that aren't being used to zero. Is this what is suppose to happen??

i also haven't been able to get the robot to respond with any of my programs can somebody give me an example program to work with to make this right??? thanks for all the help

Adam (progammer)