Thread: roll pin into output shaft
View Single Post
  #14   Spotlight this post!  
Unread 15-01-2008, 16:18
ZakuAce's Avatar
ZakuAce ZakuAce is offline
Registered User
AKA: Garrett
FRC #2077 (Laser Robotics (Alumni))
Team Role: College Student
  
Join Date: Jan 2008
Rookie Year: 2007
Location: Delafield,Wisconsin
Posts: 198
ZakuAce is a glorious beacon of lightZakuAce is a glorious beacon of lightZakuAce is a glorious beacon of lightZakuAce is a glorious beacon of lightZakuAce is a glorious beacon of light
Re: roll pin into output shaft
We had the same problem. We got one pin in, then bent 5 more (there are 2 teams at our school so we were using all of our pins up >.>) We bought some others from the hardware store and ended up drilling out one side of the shaft and put in our new ones, and now we have 4 good gearboxes. It was one hell of a time waster though, we must have spent three hours last Saturday on them.