|
Re: Can you apply an assembly extrusion to a part?
I think that's the case JD. I re-read the whole thread and I believe I may have been part of the problem. I think the OP was simply saying that they had created an assembly feature by mistake - they really wanted a part feature. Along the way various folks seemed to be suggesting that you could somehow get a part feature from an assembly feature. I agree there are ways to recover from going down one road and then backing up to get where you need to go. I probably read the OP's question more literally than it was intended and possibly others who have chimed in have all been assuming different things as well.
|