Thread: Lights, Bumpers
View Single Post
  #6   Spotlight this post!  
Unread 23-06-2002, 22:23
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Lights, Bumpers
Posted by Jerry Eckert.

Engineer from Looking for a team in Raleigh, NC sponsored by .

Posted on 1/9/2000 12:56 PM MST


In Reply to: Lights, Bumpers posted by Kyle on 1/9/2000 1:21 AM MST:



: Correct me if I have any of this wrong:
: The light must be within the size limitations of the robot, and counts towards the final weight of the robot.

I scanned the manual quickly and did not see any indication that the light is exempt from the
size and weight restrictions.

: The bumper does not have to be within the size limitations of the robot, but DOES count towards the final weight of the robot.

The bumper does not have to fit within the 30'x36' footprint; however, there are size and placement restrictions on the bumper as well (see rule M3 for details):

- may not extend more then 6' past the maximum starting dimension of the robot
- may be a maximum of 6' tall
- must be centered 6.5' off the floor


: The weight restriction is the same as last year

The weight limit is 130 lbs. I believe this is the same as last year.

Jerry



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.