Thread: STAMP II not responding to computer
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:24
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: STAMP II not responding to computer
Posted by Jerry Eckert.

Engineer from Looking for a team in Raleigh, NC sponsored by .

Posted on 1/9/2000 6:41 PM MST


In Reply to: STAMP II not responding to computer posted by Amol Mittal on 1/9/2000 5:50 PM MST:



: Hello

: I'm trying to connect the Robot Controller to my PC so I can program it.

: All the wires are in place and the power is turned on and everything is as it is supposed to be (ithink)

: When I run the stamp editor and try to Identify
: (ctrl - I), I get the following error :

: I don't know what's the problem. The power is on, and the Status LED's are all working.

: ???

: Amol Mittal

You appear to have omitted the error message text from your post.

The three obvious things to check:

1. that the programming utility is set to use the same port you are physically connected to
2. that you are set to use the correct baud rate
3. that your interface cable is good.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.