Thread: STAMP II not responding to computer
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:24
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: STAMP II not responding to computer
Posted by Steve Shade.

Other on team #7, Wizzards, from Parkville High School and Black & Decker / AAI / Raytheon.

Posted on 1/9/2000 8:42 PM MST


In Reply to: Re: STAMP II not responding to computer posted by Jerry Eckert on 1/9/2000 6:41 PM MST:



: The three obvious things to check:

: 1. that the programming utility is set to use the same port you are physically connected to
: 2. that you are set to use the correct baud rate
: 3. that your interface cable is good.

I thought of one more:
Check to make sure that the jumpper is set to the user program and not the default Scetion 9 pg 33.





__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.