Thread: STAMP II not responding to computer
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 22:24
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
1 other thing
Posted by Raul.

Engineer on team #111, Wildstang, from Rolling Meadows & Wheeling HS and Motorola.

Posted on 1/9/2000 10:21 PM MST


In Reply to: Re: STAMP II not responding to computer posted by Steve Shade on 1/9/2000 8:42 PM MST:



I know this may sound dumb, but it happened to me:
Make sure that you are indeed supplying 5 volts to the board. I had a 9 volt battery regulated to 5 volts, but the battery was actually run down below 5 volts. The LED indictor will shine brightly down to about 2 volts so it can fool you into thinking that your power source is OK.

Raul


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.