Thread: Picker Or Pickee
View Single Post
  #9   Spotlight this post!  
Unread 23-06-2002, 22:25
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
They make it, you BUY it ;-)
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 1/10/2000 6:07 PM MST


In Reply to: Aluminum extrusions. posted by Daniel on 1/10/2000 2:10 PM MST:



The aluminum extrustion rule is about as big of a loop hole in the Additional Hardware List as I have ever seen (and I LIKE IT! ;-).

It is my understanding that any constant section aluminum extrusion of any length can be used provided that it is 'off the shelf' (i.e. not a custom section extruded just for you) and its section is no bigger than 2 by 3.

This is HUGE!

There are a nearly unlimited variety available (many are available in sections intended for use with T-nuts, corner braces, etc.).

Good luck.

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.