Thread: Toughbox Assembly
View Single Post
  #40   Spotlight this post!  
Unread 16-01-2008, 19:27
Elgin Clock's Avatar
Elgin Clock Elgin Clock is offline
updates this status less than FB!
AKA: the one who "will break into your thoughts..."
FRC #0237 (Black Magic)
Team Role: Mentor
  
Join Date: May 2001
Rookie Year: 2001
Location: H20-Town, Connecticut
Posts: 7,773
Elgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond reputeElgin Clock has a reputation beyond repute
Send a message via AIM to Elgin Clock
Re: Toughbox Assembly
A quick comment.
Be careful when tightening the screws holding the lexan cover on. Cracking will most likely occur. I believe we are going to replace the lexan cover with an aluminum one because of seeing this phenomenon already in the lexan plate.


And a quick question to all:
Anyone have any troubles with the largest gear in the toughbox rubbing against the top of the 2nd washer stacked on the shaft of the CIM motor output shaft under it's spur gear when assembled?

We seem to be having some rubbing issues.. so we intend to pursue that at a later day.
__________________
The influence of many leads to the individuality of one. - E.C.C. (That's me!!)

Reply With Quote