Thread: Aluminum Extrusions
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:27
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Aluminum Extrusions
Posted by Daniel.

Coach on team #483, BORG, from Berkeley High School and NASA Ames & UC Berkeley.

Posted on 1/10/2000 2:12 PM MST



I posted this in general but it was pretty buried so I thought I'd post it again here. Sorry for redundency.

=======

Tell me about these aluminum extrusions.

I get the concept: you run alluminum through a die that cuts a long bar into a specific shape. But what about the teams that don't have this capability?? Doesn't that make our job even harder? Or maybe there's a specific profile that's standard and good and buyable. What's the deal?

Thanks in advance for any info.

-DL


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.