|
Re: pic: 973 finished parts
Actually if you took the zero at one end and then set the other end as your zero when done with the first side you are relying on the fact that your piece is to exact length, which in most cases is not too critical but if they are saying the tolerances are tight than you probably want to just indicate off a hole on the first side you did and work off of that...... Are these part of the frame?
__________________
The Red Dragons
2005 Buckeye Regional Woodie Flowers Regional Award
2005 Florida Regional Finalist Along with 1251 and 845
2006 Palmetto Regional Engineering Inspiration Award
2007 Florida Regional Judges Award and Regional Winners Along With 1251 and 86
2007 Curie Division Winner with 330 and 910
2008 Florida Regional Team Spirit Award Winners
|