Quote:
Originally Posted by DGrohnke1023
I believe Kyle's question is being misinterpreted.
We are curious about if the gearbox can handle the amount of torque the motor can send through it.
So, does any one know if the output shaft is rated to take the
motor torque x 181.
Thanks!
|
It wouldn't be a very good gearbox if it couldn't....
but seriously, if you factor in the losses at each stage due to gears the gearbox is probably in the 60-70% efficiency range (overall) which means that the gearbox would have a stall torque of approximately 261.18 N/m or 192.63 ft/lbs (depending on the actual efficiency)