Thread: leading edge of ramp?
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 22:33
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: leading edge of ramp?
Posted by Raul.

Engineer on team #111, Wildstang, from Rolling Meadows & Wheeling HS and Motorola.

Posted on 1/14/2000 3:13 PM MST


In Reply to: leading edge of ramp? posted by Joe Johnson on 1/14/2000 6:15 AM MST:



Weren't you at the kickoff? Did you not peek under the tape? Just kidding
It looks from the picture that the carpet is not wrapped. It could not be that flat against the floor if it was.
I'm also assuming the edge on the floor is beveled.
To be safe, we should ask Eric.

Raul


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.