|
Re: My Digital 'Kit of Parts' For My Friends
Posted by Eric J. Wilhelm.
Engineer on team #97 from CRLS and CHS .
Posted on 1/18/2000 1:47 PM MST
In Reply to: My Digital 'Kit of Parts' For My Friends posted by Ed Sparks on 1/14/2000 7:04 AM MST:
Is there a way to use the files in Autodesk Inventor? If I simply open one I receive the error AutoCAD 2000 not correctly installed on this system.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|