Thread: My Digital 'Kit of Parts' For My Friends
View Single Post
  #8   Spotlight this post!  
Unread 23-06-2002, 22:33
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: My Digital 'Kit of Parts' For My Friends
Posted by Eric J. Wilhelm.

Engineer on team #97 from CRLS and CHS .

Posted on 1/18/2000 3:48 PM MST


In Reply to: Re: My Digital 'Kit of Parts' For My Friends posted by Eric J. Wilhelm on 1/18/2000 1:47 PM MST:



To answer my own question in case anyone else was having the same problem:

Autodesk plans to release a MDT to Inventor translator, but it is not ready yet. The best way I've found yet is to open the files in MDT, export data as an ACIS .sat file, select objects in the assembly, and then open the .sat file in Inventor. Unfortunately the parts in Inventor have no constraints.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.