Thread: Specs for drill motor gearbox?
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:36
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
What type of spec?
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 1/16/2000 8:08 AM MST


In Reply to: Specs for drill motor gearbox? posted by Eric on 1/15/2000 9:29 PM MST:



Eric,

What spec do you want?

I can tell you that the I think the drill spec claims that the drill can provide 250 in-lbs of torque.

The ratio in low gear is about 60 to 1 and the ratio in high gear is about 20 to 1.

All that the info (probably more accuately reproduced) in in the manual.

Good Luck,

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.