[EricH]

Originally Posted by squirrel

The relieve should be near the compressor, it can be connected to a T fitting along with the pressure switch, or screwed into the other side of the compressor (it has two output ports)

Squirrel, the 125 psi relief (the one with a cork protecting one end) goes in one of those. That leaves you only one port open.

<R95> Teams are not allowed to adjust the 125-psi relief valve. The valve has been calibrated prior to shipping. The relief valve must be attached to the compressor. If the compressor is not used on the ROBOT, then an additional relief valve must be obtained and included in the primary pneumatic circuit on the ROBOT (see Rule <R91>).