Thread: Ramp Dimensions
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:36
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Ramp Dimensions
Posted by Harold Lawrence.

Other on team #458, RoboIndians, from Jefferson High School and NASA AMES.

Posted on 1/15/2000 11:28 PM MST



In the Competition Manual the ramp is described as being one that has a
15 degree incline with a 1 foot peak (1.3.5 pg 5) made of 3/4 inch plywood
for the deck. The prints, however, describe the ramp as having a 1/2 inch
plywood deck and a base that extends tip-to-tip 7' 9'. By doing a little simple
trig. this cannot be. It should measure 7' 5 5/8' from tip-to-tip for a 15 degree
rise. To me, this could possibly be a large difference from either being on or off
at the end of the match. Any thoughts on this? We're planning on making the
ramp tomorrow and would like to make it correctly.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.