Thread: The Pneumatics System
View Single Post
  #3   Spotlight this post!  
Unread 23-06-2002, 22:37
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: The Pneumatics System
Posted by Rick Berube.

Engineer on team #121, Rhode Warriors, from Middletown H.S..

Posted on 1/18/2000 6:10 PM MST


In Reply to: Re: The Pneumatics System posted by Ed Sparks on 1/16/2000 11:01 AM MST:



: My understanding is that it is a volume of compressed air @ 100 psi but that the kit includes a regulator that we are required to use that is set to 60 psi.

: Ed Team34

Yes the regulator is 60 psi maximum, but can be regulated downward. What this means is that if you don't need the full 60 psi to operate your robot mechanisms, you can tune the regulator down and make the air in your tank last longer.

Rick


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.