View Single Post
  #15   Spotlight this post!  
Unread 21-01-2008, 19:00
Dick Linn's Avatar
Dick Linn Dick Linn is offline
Registered User
no team (Synergy)
 
Join Date: Jan 2003
Rookie Year: 2001
Location: Midlothian, VA
Posts: 679
Dick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond repute
Send a message via AIM to Dick Linn
Re: what Chain size and tensioner to use for the drivetrain

HDPE is readily available in cutting boards, laundry detergent bottles and other things marked with the #2 recycling symbol with the HDPE or PE-HD printed below the triangle. Think milk jugs, eh?

If you keep your chain runs short, use quality components and align them and occasionally lubricate the chain, you shouldn't have a lot of chain tensioning problems. I agree that if your design allows the primary drive/gearbox to be adjusted or shimmed slightly, it makes life simple. One time, we needed a tensioner for a long chain run, so we cut a guide groove in some skateboard wheels and used them as rollers. Worked marvelously, and cost virtually nothing. The only other time, we stuffed a narrow piece of HDPE into a channel in some 80/20, as the chain needed to go over a rather misplaced structural rail in its path. frtgtgf'ikb n

(The last comment is from our kitten, who jumped up on the laptop twice and managed to shut everything down a few minutes ago. Thank goodness Firefox cached everything... I wouldn't want to deprive y'all of these words of wisdom amongst the cussing...)
__________________
Richard Linn

Proud father of Marine LCpl. Karl R. Linn
Co-founder Team 975
KIA, Iraq 1/26/2005