Thread: How many robots on the bar in one match?
View Single Post
  #9   Spotlight this post!  
Unread 06-23-2002, 10:39 PM
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: How many robots on the bar in one match?
Posted by Quentin Lewis.

Engineer on team #42, P.A.R.T.S - Prececision Alvirne Robotics Technology Systems, from Alvirne, Hudson NH.

Posted on 1/17/2000 10:50 AM MST


In Reply to: How many robots on the bar in one match? posted by Mike Kulibaba on 1/16/2000 11:49 PM MST:



> I haven't watched the video yet but can anyone tell me how
> many robots they think could fit on the bar at one time?
> can only 1? all 4? Can 2 fit on but it will take some very
> high tech movements? I'm sure when I'll watch the video
> I'll have a better idea but I just wanted your input. thanks
> and good luck to everyone

Since the ramp is 8 feet wide, and the robots are about 3 feet wide, it would seem that you can easily get two of them side by side.

Then, if you consider robots that might be designed so that they do not have to be directly under the bar in irder to grab it, you would be able to have two robots sitting on each side of the ramp attaching themselves to the bar....

Now, if all 4 of those robots attached on, and pulled themselves up all at the same time, you could see 4 robots hanging.....albeit hanging up against each other at that point. (Hanging at an angle from the bat, and bumping against each other at their bases)

I am not a Mechanical Engineer, and I suppose it depends on whether they grab the bar closer to the center, or towards the ands....but I wonder if the bar could actually hold about 500 pounds? (Anyone know?)

I would love to see the above senario attempted!

-Quentin



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.