Thread: Drill motor shaft replacement
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:42
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Drill motor shaft replacement
Posted by Charlie Affel (parent leader).

Other on team #487, SPARTANS, from Springfield HS, Springfiled MontCo, PA and PEW Charitable Trust,, Rohm & Haas, Yeager Industries.

Posted on 1/19/2000 6:57 AM MST



I've heard that a mech drawing of the suggested replacemnet output shaft for the drill motor has been posted somewhere on the net.
I have a useful but cumbersome link to our votech program and I need a proper drawing to give them in order to use the students rather than a professional machinist.
Can anybody tell me where to get this drawing?
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.