Thread: heat sinks
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:45
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
heat sinks
Posted by James Jones.

Engineer on team #267, The Demolition Squad, from North Broward & St Andrews and Motorola.

Posted on 1/21/2000 1:42 PM MST



Are these sleeves on the drill and FP motors really needed? I hear them referred to as heat sinks but it is hard for me to imagine that they significantly impact the temperature rise time of the motor, Do they serve another purpose? More importantly, do the motors work better with them or without them?


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.