Thread: Pneumatics Question
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:46
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Pneumatics Question
Posted by Thomas A. Frank.

Engineer on team #121, The Islanders/Rhode Warrior, from Middletown (RI) High School and Naval Undersea Warfare Center.

Posted on 1/22/2000 1:38 PM MST



Hello All;

Has anyone else had problems pressurizing their tank?

The tank has a 1/4 fitting (red) on it. The kit contains some 1/4 line. So far, so good...however, the 1/4 line will not properly mate with the gray (metric) fittings, and there isn't another 1/4 (red) fitting in the kit...and the metric line that does mate with the gray fitting won't mate with the 1/4 inch fitting.

What am I doing wrong?

Tom Frank


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.