[Bochek]

Its been over an hour now since it has worked.

Dashboard works fine through the usb to serial adapter.

But I am still having problems with programing it.

Last time it stopped working was in the middle of a transfer. This has happened before and i solved the problem by leaving it unpowered for 10 mins or so then re-connecting it. It by default goes into program state and i send it code.

Not working this time around. It fails to connect every single time.

Its doing this from a PC with a serial port too.

I have tried holding the program button down while powering it on, (which turn on only the power led and the program led) and i still have the same problem.

I am 100% out of ideas right now

- Bochek