[JSand]

I just downloaded the left window motor and imported it into my drawing...It didn't look quite right and then I realized the model is for a different motor (I'm assuming an older version). The difference is that the placement of the three mounting holes is the reverse of the current left window motor. If you look at the motor with the output shaft towards you, the model has 2 holes at the top and one at the bottom. The motor I have has one hole towards the top and two holes towards the bottom. If you could please update the model it would be much appreciated.

Thanks

Edit: I was looking through the site and just found a different model in the archive section. The holes are right, but the model is significantly less detailed than the other.