Thread: Laminating Polycarbonate
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:51
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Screws, my favorite glue!!!
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 1/27/2000 2:01 PM MST


In Reply to: Laminating Polycarbonate posted by Andres Teene on 1/27/2000 9:38 AM MST:



I don't know what glue we use whenever we need to stick two or more polycarb sheets together, but regardless, we always put a few screws in just for good measure. The stuff taps so well, it is an easy method to provide a bit of insurance against a laminate becoming a de-laminate ;-)

Joe J.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.