Thread: AutoCad compatibility
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 22:51
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: AutoCad compatibility
Posted by Andres Teene.

Engineer on team #159 from Poudre High School and LSi Logic.

Posted on 1/27/2000 3:39 PM MST


In Reply to: AutoCad compatibility posted by Elaine Anselm on 1/27/2000 2:52 PM MST:



I'm also having a problem importing AutoCad dwg files into Inventor. It looks like I need AutoCad installed on my system to translate the .dwg files. Any suggestions.

Thanks Andres


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.