View Single Post
  #8   Spotlight this post!  
Unread 23-06-2002, 22:51
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: 30 inches? Is there a 30 inch height reg?

Posted by Thomas A. Frank.

Engineer on team #121, The Islanders/Rhode Warrior, from Middletown (RI) High School and Naval Undersea Warfare Center.

Posted on 1/28/2000 4:07 PM MST


In Reply to: 30 inches? Is there a 30 inch height reg? posted by Joe Johnson on 1/28/2000 10:54 AM MST:



: I don't recall any 30 inch regulation.

: Wait a minute! Do you guys mean to tell me that you are actually going over to the OTHER SIDE!?!?!

: We have been planning all along to reach OVER the center in order to reach the balls against the far wall ;-)

: Maybe we should rethink things a bit.


No Joe, there's no need to rethink things. You're definitely on the right track planning to reach over the goal to pick up the balls on the floor on the far side.

It's sure to be faster than trying to drive over there.

In fact, if you make the machine stationary, you'd have all sorts of extra motors to power that arm!

Tom


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.