Thread: Machine weight and holes
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:51
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Machine weight and holes
Posted by Susanne Krussell.

Coach on team #349, Robahamas, from International Academy and Ford Motor Co..

Posted on 1/27/2000 6:37 PM MST



After reading the latest questions posted by FIRST (#136, 136), and with a good deal of amusement, my co-coach Bethany and I would like to remind Daniel on Team 483 that if he decides to reduce robot weight by drilling holes in the pneumatics tank, his team will be able to keep a fairly steady pressure of 100 kPa (1 atm).


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.