Thread: who here uses autocadd to design their robot if not everyone
View Single Post
  #10   Spotlight this post!  
Unread 23-06-2002, 22:52
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: who here uses autocadd to design their robot if not everyone
Posted by Elaine Anselm.

Engineer on team #191, X-Cats, from Jos Wilson High School and Xerox.

Posted on 1/28/2000 8:30 PM MST


In Reply to: who here uses autocadd to design their robot if not everyone posted by Matt Dickhaut on 1/27/2000 6:55 PM MST:



We are using the new Autodesk Inventor package this year and with the exception of the interoperability problems (which are pretty annoying - see the post on the technical board) find it working very well. It was very easy for the students to begin using Inventor. They started learning it in November along with 3 adults. We have 5 students who are quite proficient. We are using Inventor for subsystem designs and integration. We stopped using the package used internally at Xerox for product design because they tend to be very difficult for the students to learn, the school doe snot use the software and the adults end up doing the design, not the students.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.