Thread: who here uses autocadd to design their robot if not everyone
View Single Post
  #13   Spotlight this post!  
Unread 23-06-2002, 22:52
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Not quite...
Posted by Steve Prairie.

Student on team #173, RAGE, from Rockville High School /East Hartford High School and UTRC.

Posted on 1/30/2000 11:39 AM MST


In Reply to: Not quite... posted by Lora Knepper on 1/29/2000 6:34 AM MST:



I am a 9th grader at Rockville High School. I helped design the frame of this years robot using AutoCad LT 98, and AutoCad Inventor. I recieved the Inventor software earlier this month, and created a 3D model of our frame in about an hour. The software has helped our team to get a feel of how our robot is going to look.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.