Thread: who here uses autocadd to design their robot if not everyone
View Single Post
  #16   Spotlight this post!  
Unread 23-06-2002, 22:52
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
We export via .STL files
Posted by Joe Johnson.   [PICTURE: SAME | NEW | HELP]


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 1/30/2000 5:09 PM MST


In Reply to: another UG team posted by Ken Patton on 1/30/2000 1:49 PM MST:



Ken,

We have had good success exporting our data to the format used to make rapid prototypes via stereolithography (.stl files) and then importing them into the animation software.

From what I understand, both technologies need an efficient method to approximate non-flat surfaces. It has worked for us for a few years now.

Joe J.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.