Thread: Pneumatics compatibility
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 22:54
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Pneumatics compatibility
Posted by Michael Spryn.

Engineer on team #340, Grr, from Churchville-Chili High School and Nortel Networks.

Posted on 1/29/2000 7:37 AM MST



Regarding the SMC Pneumatics supplied parts, is something missing? Our understanding from the pneumatics workshop at the kick-off is that the electric solenoids (SY113) were intended to be used to control the power valves (SYA3120 & SYA3320). But (with the parts we received) the electric selenoids appear to accept ONLY 4mm tubing, and the control port on the power valves accept ONLY 6mm tubing. Thus, we can not connect the output from the solenoid to the power valves. We've rigged something to work temporarily, but we're wondering if we're missing something (either parts or know-how).


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.