Thread: Programming
View Single Post
  #6   Spotlight this post!  
Unread 23-06-2002, 22:55
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Programming
Posted by Jerry Eckert.

Engineer from Looking for a team in Raleigh, NC sponsored by .

Posted on 1/31/2000 9:59 AM MST


In Reply to: Programming posted by Justin Stiltner on 1/30/2000 10:53 PM MST:



: I hope sombody knows how to accomplish this

: I need to be able to control a pwm with a button and a joystick, specifically I need to be able to move the joystick and have the motor respond normally but when the top button is pressed the motor should go to full speed in whatever direction the joystick is in or foward if the joystick is centered

: I think I have figured out how to do this but I wont get to find out untill tomarrow.

: also what is the function and what does each part of the serout command mean??

Try this:


IF (p1_sw_top = 0) then skip_full_drive
LOOKDOWN drive,
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.