Thread: dashboard data stream
View Single Post
  #4   Spotlight this post!  
Unread 23-06-2002, 22:56
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: dashboard data stream
Posted by Nate Smith.

Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.

Posted on 1/31/2000 3:57 PM MST


In Reply to: Re: dashboard data stream posted by Joe Ross on 1/31/2000 12:05 PM MST:



I don't know for sure, but since the direct sensor outputs are not output by the control program, I'm assuming that the analog inputs on the robot are sent directly to the OI without going through the user program. So, in order to do this, you'd have to figure out a way to wire one of the PWM outputs to one of the analog inputs on the RC. It does not appear to be able to be done through the control program.

Nate

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.