View Single Post
  #1   Spotlight this post!  
Unread 30-01-2008, 22:01
aznzricex aznzricex is offline
Registered User
FRC #1403
 
Join Date: Jan 2008
Location: New Jersey
Posts: 1
aznzricex is an unknown quantity at this point
Powering the IR Board

Hey, it's my first time posting on Chief Delphi....!!!

In the rules it says that all custom circuits have to be protected by a 20A breaker... so is the IR board considered to be a custom circuit or no?

I was thinking of just powering the IR board using the fuse block, and connecting pin 1 and 3 to a PWM going to the digital input 18 and connecting pin 2 and 4 to the digital input 17... I've been reading on the forums that you are able to power the IR board thru the Robot Controller.... and then the signals from pins 5,6,7,8 will be sent to some digital input signal on the Robot controller...

so basically i'm just asking will this work?

just want to make sure, we already friend one RC board lol....