|
Re: gears....?
Posted by Dan.
Student on team #10, BSM, from Benilde-St. Margaret's and Banner Engineering.
Posted on 2/1/2000 4:39 PM MST
In Reply to: gears....? posted by Janna on 2/1/2000 4:26 PM MST:
Check out Rush Gears (link below.) Never used them, but many have recommended them.
G'Luck
:-Dan
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|